Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 3 de 3
Filtrar
Mais filtros










Intervalo de ano de publicação
1.
Rev Esp Salud Publica ; 932019 12 17.
Artigo em Espanhol | MEDLINE | ID: mdl-31844039

RESUMO

OBJECTIVE: The daily consumption of fluoridated water is one of the most beneficial measures in dental caries prevention. The objective of this paper was to analyze the content of fluorine and heavy metals in the bottled natural mineral water available in stores in Spain. METHODS: A descriptive and transversal study was done throughout 2019. Analysing a total of 20 bottled waters marketed in Spain during this year. Mainly, fluoride concentration (ppm/ml) was analyzed with an ion-specific electrode (Orion model 96-09, Orion Research, Cambridge, MA) coupled to an ion analyzer (Orion EA-940). The heavy metals were analyzed by ICP-MS (Agilent model 7900). A descriptive statistical study of the data was carried out. RESULTS: The minimum value of fluorine found was 0.05 ppm and the maximum 0.95ppm. 80% of the brands analyzed contain less than 0.6 ppm F. Only 1 brand exceeds 0.8 ppm F. Chromium and arsenic were the heavy metals present in all brands, without exceeding the maximum dose. No brand of bottled water indicated heavy metals on the label, and only 1 mark indicated the fluoride concentration on the label. CONCLUSIONS: There is a great variability in the chemical composition of bottled waters marketed in Spain. Most have a fluoride concentration lower than that recommended to prevent tooth decay, which would require an extra supply of fluoride. In the bottled waters analyzed there are heavy metals but they did not exceed the maximum doses established by legislation.


OBJETIVO: El consumo diario de agua fluorada es una de las medidas mas beneficiosas en la prevención de la caries dental. El objetivo de este estudio fue analizar el contenido de flúor y metales pesados en el agua mineral natural embotellada disponible en los comercios de España. METODOS: Se realizó un estudio descriptivo y transversal a lo largo de 2019, analizando 20 marcas de aguas embotelladas comercializadas en España en ese año. Se midió principalmente la concentración de flúor (partes por millón/mililitro) (ppm/ml), que fue analizada con un electrodo ion-específico (modelo Orión 96-09, Orion Research, Cambridge) acoplado a un analizador de iones (Orion EA-940). Los metales pesados se analizaron mediante ICP-MS (Agilent modelo 7900). Se realizó un estudio estadístico descriptivo de los datos. RESULTADOS: El valor mínimo de flúor encontrado fue de 0,05 ppm y el máximo de 0,95 ppm. El 80% de las marcas analizadas contenían menos de 0,6 ppm F. Solamente una marca superó las 0,8 ppm F. Cromo y arsénico fueron los metales pesados presentes en todas las marcas, sin superar la dosis máxima. Ninguna marca de agua embotellada indicaba los metales pesados en la etiqueta, y solo una marca indicó la concentración de flúor en la etiqueta. CONCLUSIONES: Existe una gran variabilidad en la composición química de las aguas embotelladas comercializadas en España. La mayoría tienen una concentración de fluoruro inferior a la recomendada para prevenir la caries dental, por lo que se necesitaría un aporte extra de flúor. En las aguas embotelladas analizadas existen metales pesados, pero no superan las dosis máximas establecidas por la legislación.


Assuntos
Cárie Dentária/prevenção & controle , Água Potável/química , Fluoretos/análise , Fluorose Dentária/prevenção & controle , Metais Pesados/análise , Águas Minerais , Poluentes Químicos da Água/análise , Estudos Transversais , Cárie Dentária/etiologia , Água Potável/análise , Fluorose Dentária/etiologia , Humanos , Águas Minerais/análise , Espanha , Qualidade da Água
2.
Rev. esp. salud pública ; 93: 0-0, 2019. tab
Artigo em Espanhol | IBECS | ID: ibc-189460

RESUMO

FUNDAMENTOS: El consumo diario de agua fluorada es una de las medidas mas beneficiosas en la prevención de la caries dental. El objetivo de este estudio fue analizar el contenido de flúor y metales pesados en el agua mineral natural embotellada disponible en los comercios de España. MÉTODOS: Se realizó un estudio descriptivo y transversal a lo largo de 2019, analizando 20 marcas de aguas embotelladas comercializadas en España en ese año. Se midió principalmente la concentración de flúor (partes por millón/mililitro) (ppm/ml), que fue analizada con un electrodo ion-específico (modelo Orión 96-09, Orion Research, Cambridge) acoplado a un analizador de iones (Orion EA-940). Los metales pesados se analizaron mediante ICP-MS (Agilent modelo 7900). Se realizó un estudio estadístico descriptivo de los datos. RESULTADOS: El valor mínimo de flúor encontrado fue de 0,05 ppm y el máximo de 0,95 ppm. El 80% de las marcas analizadas contenían menos de 0,6 ppm F. Solamente una marca superó las 0,8 ppm F. Cromo y arsénico fueron los metales pesados presentes en todas las marcas, sin superar la dosis máxima. Ninguna marca de agua embotellada indicaba los metales pesados en la etiqueta, y solo una marca indicó la concentración de flúor en la etiqueta. CONCLUSIONES: Existe una gran variabilidad en la composición química de las aguas embotelladas comercializadas en España. La mayoría tienen una concentración de fluoruro inferior a la recomendada para prevenir la caries dental, por lo que se necesitaría un aporte extra de flúor. En las aguas embotelladas analizadas existen metales pesados, pero no superan las dosis máximas establecidas por la legislación


BACKGROUND: The daily consumption of fluoridated water is one of the most beneficial measures in dental caries prevention. The objective of this paper was to analyze the content of fluorine and heavy metals in the bottled natural mineral water available in stores in Spain. METHODS: A descriptive and transversal study was done throughout 2019. Analysing a total of 20 bottled waters marketed in Spain during this year. Mainly, fluoride concentration (ppm/ml) was analyzed with an ion-specific electrode (Orion model 96-09, Orion Research, Cambridge, MA) coupled to an ion analyzer (Orion EA-940). The heavy metals were analyzed by ICP-MS (Agilent model 7900). A descriptive statistical study of the data was carried out. RESULTS: The minimum value of fluorine found was 0.05 ppm and the maximum 0.95 ppm. 80% of the brands analyzed contain less than 0.6 ppm F. Only 1 brand exceeds 0.8 ppm F. Chromium and arsenic were the heavy metals present in all brands, without exceeding the maximum dose. No brand of bottled water indicated heavy metals on the label, and only 1 mark indicated the fluoride concentration on the label. CONCLUSIONS: There is a great variability in the chemical composition of bottled waters marketed in Spain. Most have a fluoride concentration lower than that recommended to prevent tooth decay, which would require an extra supply of fluoride. In the bottled waters analyzed there are heavy metals but they did not exceed the maximum doses established by legislation


Assuntos
Humanos , Cárie Dentária/prevenção & controle , Água Potável/química , Fluoretos/análise , Fluorose Dentária/prevenção & controle , Metais Pesados/análise , Águas Minerais/análise , Poluentes Químicos da Água/análise , Estudos Transversais , Cárie Dentária/etiologia , Água Potável/análise , Fluorose Dentária/etiologia , Qualidade da Água
3.
PLoS One ; 13(12): e0208856, 2018.
Artigo em Inglês | MEDLINE | ID: mdl-30533062

RESUMO

BACKGROUND: International guidelines on the prevention of caries recommend sealing of the pits and fissures of the permanent molars. There is no evidence on which type of material is most effective on demineralized enamel. AIM: To evaluate the microleakage of a conventional light-cured, resin-based fissure sealant (LCRBS), GrandiO Seal, and a resin-modified glass ionomer sealant (RMGIS), Vitremer, after application of a fluoride varnish, Bifluorid 12, on demineralized enamel. DESIGN: 80 human third molars were divided into eight groups. The groups combined the three study factors (1) type of enamel (intact or demineralized); (2) enamel non-varnished or varnished with Biflourid12; and (3) type of sealant (GrandiO Seal or Vitremer). The percentage of microleakage after thermocycling was measured using imaging analysis software. The Kruskal-Wallis plus Dunn tests were used to compare differences in microleakage in the different groups. RESULTS: The lowest microleakage was in the unvarnished groups, and was the same for GrandiO Seal and Vitremer. When varnish was applied, microleakage was greater in demineralized enamel than in intact enamel for both LCRBS and RMGIS. CONCLUSION: The application of fluoride varnish on demineralized enamel increases the microleakage of both GrandiO Seal and Vitremer.


Assuntos
Cariostáticos , Resinas Compostas , Esmalte Dentário , Fluoretos , Cimentos de Ionômeros de Vidro , Selantes de Fossas e Fissuras , Humanos
SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA
...